Custom Vitrine Sizing for Hotel Lobbies: Height, Depth and Shelf Spacing by Display Type
Custom vitrine dimensions work best when they start from the objects on show, not from a generic cabinet size. This guide gives practical height, depth and shelf spacing references for books, art, bottles and souvenirs in hotel lobbies.
Custom vitrine dimensions should be set by the objects you plan to display, the sightlines in the lobby and the way guests and staff will use the cabinet. A cabinet that looks right in a render can still waste shelf space or hide the best pieces if the proportions are wrong. The reference ranges below are starting points; final sizes always depend on your drawings, your products and the space available.
Why display type should drive the dimensions
Most size guides begin with the room or the cabinet. In a hotel lobby it is more useful to begin with the item. A row of leather-bound books, a framed print and a set of souvenir bottles all need different internal heights and depths, even if the outer cabinet looks similar.
Start by listing every object, its largest dimension and how it will stand: flat, upright, leaning or hanging. Add 2 to 5 cm (0.8 to 2 in) of air above each item so that it does not look cramped and so that staff can place and remove it easily. This simple list becomes the brief for your factory.
General planning rules for lobby vitrines
Before looking at individual display types, a few rules apply to almost every lobby cabinet.
- Eye level matters most. The main display zone should sit roughly between 90 and 170 cm (35 to 67 in) above the floor, so guests of different heights can see it without bending or stretching.
- Upper shelves are for light, low-interest items. Anything above about 180 cm (71 in) is hard to see and hard to reach for cleaning.
- Lower zones can be closed storage. A solid base of 60 to 90 cm (24 to 35 in) hides stock, spare items and wiring, and keeps the glass part at a comfortable viewing height.
- Check the ceiling and lighting. Leave room for lighting, a cornice or a ceiling fixture, and make sure the cabinet does not collide with sprinklers or air outlets.
Dimension reference by display type
The table below summarises typical planning ranges. Treat them as starting points to confirm with your designer and your manufacturer.
| Display type | Cabinet depth | Shelf clear height | Typical overall height | Notes |
|---|---|---|---|---|
| Books and magazines | 25-35 cm (10-14 in) | 30-38 cm (12-15 in) | 180-220 cm (71-87 in) | Allow for large coffee-table books lying flat |
| Framed art and plaques | 12-25 cm (5-10 in) | Fixed to artwork size plus margin | 160-210 cm (63-83 in) | Rear panel fixings or picture rail |
| Bottles and glassware | 30-40 cm (12-16 in) | 30-40 cm (12-16 in) | 180-210 cm (71-83 in) | Use thicker glass or timber shelves for weight |
| Souvenirs and gift items | 25-40 cm (10-16 in) | 20-30 cm (8-12 in) | 150-200 cm (59-79 in) | Tighter spacing, more shelves |
| Single feature objects | 40-60 cm (16-24 in) | One open volume | 120-200 cm (47-79 in) | Often a plinth with a glass hood |
Books and printed material
Hotel libraries and lobby bookcases usually carry a mix of formats. Standard hardbacks need about 25 to 30 cm (10 to 12 in) of clear height, while large art or travel books may need 35 to 40 cm (14 to 16 in). Mixing two shelf heights in one cabinet gives a more tailored look and holds more items.
Depth of 25 to 35 cm (10 to 14 in) is usually enough. Go deeper only if you want to display books face out or place small objects in front of the spines.
Art, plaques and framed pieces
For flat items, a shallow cabinet is often more elegant than a deep one. Depth of 12 to 25 cm (5 to 10 in) keeps the piece close to the glass and avoids shadows from the front edge. If you plan to stand items on a ledge, add a lip or groove so they cannot slide.
Measure the framed piece, including any hanging hardware, and give the factory the exact size. For larger works, consider a fixed rear panel with discreet mounting points instead of shelves.
Bottles, glassware and bar displays
Bottles are heavy and tall. A clear shelf height of 30 to 40 cm (12 to 16 in) covers most wine and spirit bottles, but check your own range, because some premium bottles are taller. Depth of 30 to 40 cm (12 to 16 in) lets you place two rows when needed.
Because of the weight, discuss shelf thickness, support spacing and glass type with your manufacturer. Our separate guide on shelf load and glass thickness covers this in more detail. For bar and restaurant use, also consider ventilation and heat from lighting, which can affect labels and contents over time.
Souvenirs and gift shop items
Small products are best shown on more shelves at tighter spacing. A clear height of 20 to 30 cm (8 to 12 in) works for most boxed items, mugs and figurines. A depth of 25 to 40 cm (10 to 16 in) is practical when staff need to reach in and restock.
If the cabinet doubles as a small retail point, think about locking doors, a counter height section and clear signage space. These choices affect overall dimensions as much as the products themselves.
Shelf spacing: fixed or adjustable?
Fixed shelves give a clean look and strong support but lock you into a layout. Adjustable shelves, using pins or rails, let you change displays seasonally or when items change. For hotels that rotate content, adjustable spacing is usually the more practical choice.
A good compromise is to fix the top and bottom zones and make the middle zone adjustable. Specify the pitch of the adjustment holes in the drawings, commonly 32 mm (1.3 in) or a similar standard, so that each position is consistent across cabinets.
Width, modules and lobby layout
Width is often decided by the wall or niche, but it also affects shelf strength. Long glass or timber spans can sag, so a centre support or a thicker shelf may be needed for widths beyond roughly 80 to 90 cm (31 to 35 in), depending on the load and material.
If the lobby wall is long, consider modules of similar width with a consistent shelf line. This looks tidy, simplifies production and makes replacement easier. For narrow or corner sites, a custom shape may be better than forcing a standard cabinet into the space.
Practical points to check before ordering
- Clear width of doors, lifts and corridors, so large cabinets can be delivered and installed.
- Floor levels and skirting, which can affect the base height and stability.
- Wall type and fixing method for tall units that need anchoring.
- Lighting position, driver access and cable routing.
- Glass type, door style and lock requirements for public areas.
- Cleaning access for staff, including the top and the back.
Worldwide orders and bulk projects
We make custom vitrines to project drawings in our Istanbul factory and supply hotel projects and bulk programmes in different regions. When you order several cabinets, it helps to standardise a small number of sizes across the property. This keeps tooling simple, makes spare parts easier to manage and can make production planning more efficient.
Costs and lead times depend on quantity, materials, glass, lighting and finish, so we review each project individually rather than quoting from a generic list. A mock-up or sample cabinet is a sensible step if your order is large or the display is complex.
How to brief your manufacturer
To get an accurate quotation and a cabinet that fits, send the following:
- A list of items to be displayed with their dimensions and weights.
- Lobby plans or elevations showing the available wall or floor area.
- Preferred materials, finish and glass type.
- Lighting, lock and security requirements.
- Quantity, delivery location and target installation period.
Next step
If you are planning lobby display furniture, send us your drawings, item list or reference photos. We will review the sizes, suggest practical adjustments and prepare a quotation for your project.
Sıkça Sorulan Sorular
What is a good standard depth for a hotel lobby vitrine?
There is no single standard, but 25 to 40 cm (10 to 16 in) suits most books, bottles and souvenirs. Framed art and flat items can use 12 to 25 cm, while feature objects may need 40 cm or more. Measure your largest item and add clearance.
How much space should be left above items on a shelf?
Allow roughly 2 to 5 cm (0.8 to 2 in) above each object. This keeps the display uncluttered, lets staff place and remove items easily and gives room for lighting. Taller or more valuable pieces may justify a little more space.
Should vitrine shelves be adjustable in a hotel lobby?
Adjustable shelves are usually the more practical choice if displays change with seasons, promotions or collections. Fixed shelves look cleaner and can be stronger. Many projects combine both, fixing the top and bottom zones and making the middle zone adjustable.
What height is best for the main display zone?
Place the main display roughly between 90 and 170 cm (35 to 67 in) from the floor so most guests can see it comfortably. Use higher shelves for lighter, less important items and lower sections for closed storage.
Can you make vitrines in custom sizes for bulk hotel orders?
Yes. We produce custom vitrines to project drawings and can supply multiple units for hotel programmes worldwide. Pricing and lead time depend on size, quantity, materials and finish, so send your drawings or item list for a project quotation.
Every hotel project is different. Send us your drawings or room schedule for a tailored proposal on materials, lead time and shipping.





